W10811958 Whirlpool Surface Burner Cap

DIY Guide to Replacing Whirlpool W10811958 CAP-BURNER

Replacing the Whirlpool W10811958 CAP-BURNER is a simple do-it-yourself (DIY) repair. With some basic tools, you can replace this part on your own. Follow these easy steps to replace the Whirlpool W10811958 CAP-BURNER.

Step 1: Disconnect the Power Supply

For safety reasons, it’s important to disconnect the power supply to the appliance before attempting any repairs. Unplug the appliance and turn off the gas supply to the oven.

Step 2: Remove Existing CAP-BURNER

Open the oven door to access the existing CAP-BURNER. Carefully remove the old CAP-BURNER by removing the screws that are holding it in place. Once the screws are removed, carefully lift out the old CAP-BURNER.

Step 3: Install New CAP-BURNER

Place the new CAP-BURNER into position. Secure the new CAP-BURNER with the screws that were used to attach the old one. Make sure the screw holes line up and the CAP-BURNER is secure.

Step 4: Test New CAP-BURNER

Once the new CAP-BURNER is installed, it’s time to test it. Plug the power supply back into the appliance and turn on the gas supply. Turn on the oven and check for any leaks around the new CAP-BURNER. If there are no leaks, the installation was successful.

Your Whirlpool W10811958 CAP-BURNER is now replaced. By following these easy steps, you can quickly and easily replace this part on your own. For more DIY tips and tricks, visit our website and blog.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.