DA82-02869A Samsung Refrigerator Water Filter Case Assembly

Step 1: Unplug your Samsung refrigerator from the wall outlet.

Step 2: Locate the DA82-02869A Samsung Refrigerator Water Filter Case Assembly. This is usually found on the lower left side of the refrigerator.

Step 3: Open the grille and locate the filter housing. Remove the two screws from the base of the filter housing.

Step 4: Slide the housing out of the grille and turn it to the side to remove.

Step 5: Unscrew the cap on the water filter assembly and pull out the old filter.

Step 6: Insert the new water filter into the housing and screw the cap on the assembly back in place.

Step 7: Reinsert the housing into the grille and replace the two screws at the base of the housing.

Step 8: Reconnect the power cord to the refrigerator and plug it in.

Step 9: Run cold water through the fresh water dispenser for one minute to activate the new filter.

Step 10: Discard the old filter and enjoy the taste of filtered water provided by your new DA82-02869A Samsung Refrigerator Water Filter Case Assembly!

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.