WP9870037 Whirlpool Ram Stop

DIY Guide to Replacing the Whirlpool WP9870037 STOP-RAMP

Replacing the Whirlpool WP9870037 STOP-RAMP is a relatively easy job that can be accomplished with minimal tools. This DIY guide will provide step-by-step instructions for replacing this part so you can make sure your Whirlpool appliance is functioning safely and efficiently.

Step 1: Unplug the appliance from the power source.

Step 2: Inspect the area around the STOP-RAMP to ensure no foreign objects are present that could interfere with the repair.

Step 3: Locate the screws that hold the STOP-RAMP in place. These screws can be found under the appliance, near the back of the unit.

Step 4: Remove the screws using a Phillips head screwdriver.

Step 5: Once the screws have been removed, carefully pull out the STOP-RAMP.

Step 6: Clean the area where the STOP-RAMP was located with a damp cloth, removing all dust and debris.

Step 7: Place the new STOP-RAMP in the area and reattach the screws.

Step 8: Plug the appliance back into the power source and test the function of the STOP-RAMP.

With these simple steps, you can easily replace the Whirlpool WP9870037 STOP-RAMP and restore your Whirlpool appliance to proper working order. Be sure to use caution when replacing any part of an appliance, as improper installation can cause serious damage.

Please keep in mind, these instructions are for general guidance and should always be used in conjunction with the manufacturer's manual, if available.